With a pressing power of 548 kN and employing low-noise and energy-saving technology, the HSM V-Press 860 is the most economical and ecological solution for your waste disposal.

To fill the press, the upper half of the doors is pushed down Automatically opens after the compression process Opened upper edge of the gate can be used as storage and therefore facilitates the filling Automatic start of the pressing process after closing the door Easily operated

Counter-rotating thread for quick opening and closing Mounted at an ergonomic height Easy to handle Opening aid for expansive materials

With the rapid motion technology developed specifically for the V-Press series the power consumption and drive power are significantly reduced and at the same time the through put rate increases. The cycle time is reduced with this technology by up to 40% compared to conventional drives. Due to special pump technology the machines are particularly quiet.

Massive press ram and extremely robust press plate guidance.

Pressing procedure starts automatically upon closing the door. Upon opening the door a security switch assures an automatic stop of the pressing procedure.

The entire pressing cycle, beginning with closing the door, is fully automatic. A text display informs you in detail about the respective status of the process. When the pressing procedure comes to an end, the sliding door opens automatically. Extracting the bale is simple and easy, and it can be comfortably transported on a pallet

Thanks to the newly developed HSM TCS (TorsionControlSystem), the angle of the press ram is minitored continuously in every direction avoiding one sided overcharge. Optimising the pressing procedure and assures longer service life.